Psion EP10 User Manual Page 209

  • Download
  • Add to my manuals
  • Print
  • Page
    / 266
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 208
Chapter 7: Peripheral Devices & Accessories
Cable Arrangement
195
Psion EP10 Hand-Held Computer User Manual
Figure 7.10 RAM Mount – Model Number RAM-B-166-202U
To accommodate the service loop of the power cable, leave a 10.2 cm (4 in.) clearance at the bottom of the
vehicle cradle. Leave a 17.8 cm (7 in.) clearance at the top of the vehicle cradle to allow easy removal of
the EP10. When selecting a mounting location, refer to the assembly instructions that are packaged
with the pedestal.
If you choose to use a third party company-produced cradle, Psion cannot take responsibility for the effects
of that third party product when it causes failure to our device.
7.11.2 Cable Arrangement
Before installing cables between the cradle and other devices, review the following:
Ensure that drilling holes will not damage the vehicle or its wiring.
Protect cable runs from pinching, overheating and physical damage.
Use grommets to protect cables that pass through metal.
Use plastic straps and tie-downs to secure cables and connectors in their desired location, away from
areas where they may get snagged or pulled.
Keep cables away from heat sources, grease, battery acid and other potential hazards.
Keep cables away from control pedals and other moving parts that may damage the cables or interfere
with the operation of the vehicle.
7.11.3 Electrical Requirements
There are two options to power your EP10 once it is inserted in the Powered Vehicle Cradle – the Vehicle
Power Outlet Adaptor (model no. RV3050) or the 10 foot DC Power Extension Cable (model no. RV 1205).
Important: Before Psion releases a product, our engineering team exposes that product to
vibration tests to ensure the EP10 will remain secure during normal use. But as a
low cost mount, the cradle will not defend against shock if the vehicle undergoes a
front or rear impact. Take care to mount the cradle in an upright position in case
of accidents.
Warning: Applying a voltage above 36VDC or reversing polarity may result in permanent
damage to the vehicle cradle power section and will void the product warranty. For
safety reasons, disconnect the vehicle cradle power cable when the vehicle
battery is being charged by an source other than the vehicle alternator.
Page view 208
1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 265 266

Comments to this Manuals

No comments